Sharp SF-2050 Service Manual page 97

Main Sub
Item
code code
3 RADF individual
load check
3
2 Sorter sensor check
Contents
When the sub code is entered, the LCD shows the following
display. With the RPL on, enter the RADF load code to be
checked, and the code will be displayed on the copy quantity
display. Then press the START key to start checking.
SIMULATION NO. 2-3
1..DFM FORWARD.
2..DFM REVERSE.
3..DTM FORWARD.
4..DTM REVERSE.
5..DTC
6..DFSOL
7..DRSOL
8..SSOL
9..DTBC
Code Display
Paper feed motor forward
1 DEM FORWARD
rotation
Paper feed motor reverse
2 DEM REVERSE
rotation
Transport belt motor forward
3 DTM FORWARD
rotation
Transport belt motor reverse
4 DTM REVERSE
rotation
5 DTC Transport belt clutch
6 DFSOL Paper feed solenoid
7 DRSOL Reverse solenoid
8 SSOL Shutter solenoid
9 DTBC Brake clutch
When the main code is inputted, the LCD shows the following
display and a sub code blinks on the copy quantity display.
With the RPL on, enter the desired sub code and press the
START key to start the operation.
SIMULATION NO. 3
INPUT 1~3
1. (NO PROGRAM)
2. SORTER SENSOR TEST.
3. SORTER COMPONENT OPERATION TEST.
When the sub code is entered, the LCD shows the following
display to allow checking of the sorter sensor. (When sensed,
the display is highlighted.)
[When the sorter is installed]
SIMULATION NO. 3-2
SORTER
SPID , SPOD , IULD
IPSS
SJOD , STCD , SBCD
[When the staple sorter is installed]
SIMULATION NO. 3-2
STAPLE SORTER
JSW , BHPS , LCHPS
SPPD , BPED
SCSW , SHPS , SCS
SPE
9 – 4
Name
, ILLD , IHPS
, SGHPS , SPID
, SSD , SED
Adjustment value
Ref. page
Adjustment
Default
scope
— — —
— — —