Sharp SF-2050 Service Manual page 32

Unplug the copier and follow the procedure below.
1. Mount the ADF onto the copier.
Remove the 2 cut-outs from the upper cabinet panel of the copier.
Cut-outs
Install the 2 ADF mounting screws.
ADF mounting screw
Fit the holes in the hinges of the ADF onto the ADF mounting screws
and secure the ADF with the two ADF securing screws.
ADF securing screw
ADF mounting screw
ADF securing screw
Upper rear
cabinet panel
ADF mounting screw
6 – 13
2. Adjust the angle of ADF.
Loosen the two fixed screws for the angle adjusting panel which
locate on the hinge angle and then fasten the loosened screws while
raising the angle adjusting panel completely.
Angle adjusting panel
Fixed screws
3. Connect the ADF connector.
Remove the connector cover from the copier's rear cabinet panel.
Next, connect the ADF connector to the connector on the copier.
ADF connector
Connector on copier
Connector cover