Table of Contents
Advertisement
8
Loosen two screws (blue) and remove the cleaning blade.
9
Remove three screws and remove the toner receiver.
F
Remove two screws and the process sensor harness connector,
and remove the process sensor PWB.
G
Remove two bearings of the DR drive shaft and the DR pawl
returning SP-L, and remove the drum pawl drive plate.
H
Remove two DR pawl springs from the hook, and remove the
separation pawl together with the drum pawl shaft.
I
Remove the separation pawl from the drum pawl shaft.
J
Remove one screw and remove the process arm spring.
K
Remove the separation solenoid harness connector, and remove
the separation solenoid.
7 – 2
Advertisement
Table of Contents
