Table of Contents
Advertisement
Main
Sub
Item
code
code
27
03
04
Contents
During execution, the following message is displayed on the
basic screen.
SIMULATION NO.27-3
SELECT NUMBER TO CHANGE DATA.
1. PPC ID
2. PC/MODEM ID
(When "1" is selected:)
The following message (A) and (B) are displayed in the basic
screen.
SIMULATION NO.27-3
PPC ID:X:[*],Y:[→] ••••••• (A)
SIMULATION NO.27-3
PPC ID:X:[*],Y:[→] ••••••• (B)
*****(2)***** → ••••••• (3) •••••••
(Note) "*****(2)*****": Previously registered telephone
number
When message (B) is displayed, "PPC ID" can be set with 10
key pad, and the set ID number is displayed in "•••••••(3)•••••••"
(Max. 10 digits). Then communication with the modem is effec-
tive. When the start key is pressed, the new telephone number
is registered and the following massage is displayed.
SIMULATION NO.27-3
PPC ID#: ••••••• (3) •••••••
(When "2" is selected:)
PPC/MODEM ID can be set similarly to 1.
During execution, the following message is displayed on the
basic screen, allowing setting of service start/end.
SIMULATION NO.27-4
1. SERVICE START.
2. SERVICE END.
(Service start)
When "1" is selected, the following message is displayed, and
the PPC sends "SERVICE START" command to th
PC/MODEM.
SIMULATION NO.27-4
SERVICE START.
When the PC/MODEM receives the command normally, the
following message is displayed.
SIMULATION NO.27-4
SERVICE START
Complete...
(Service end)
When "2" is selected, the following message is displayed, and
the PPC sends "SERVICE END" command to the PC/MODEM.
SIMULATION NO.27-4
SERVICE END
When the PPC receives the command normally, the following
message is displayed.
SIMULATION NO.27-4
SERVICE END.
Complete...
9 – 24
Adjustment value
Ref. page
Adjustment
Default
scope
—
—
—
Advertisement
Table of Contents
