Table of Contents
Advertisement
Main
Sub
Item
code
code
2
Automatic
developer
adjustment
26
1
Option setting
Contents
When the sub code is entered, the drum motor rotates for 3
minutes to stir the developing unit and monitor the toner den-
sity sensor value 16 times. Then the average value is stored as
the adjustment value.
During rotation of the drum motor, the toner density sensor
output value is displayed on the LCD.
When an abnormal input of the sensor value occurs, it is
judged as "EU" (Under toner) or "EL" (Over toner) trouble and
the adjustment value is not stored.
When the main code is inputted, the LCD shows the following
display and a sub code blinks on the copy quantity display.
With the RPL on, enter the desired sub code and press the
START key to start the operation.
[Destination setting: SEC/SECL]
SIMULATION NO. 26
INPUT 1~7
1. OPTION SETUP.
2. (NO PROGRAM)
3. AUDITOR COIN VENDOR SETUP.
4. (NO PROGRAM)
5. COUNTER MODE SETUP.
6. DESTINATION SETUP.
7. DRUM SENSITIVITY SETUP.
8. LCC EMPTY DATA SETUP.
[Destination setting: Others SEC/SECL/JAPAN]
SIMULATION NO. 26
INPUT 1~7
1. OPTION SETUP.
2. LCC SETUP.
3. AUDITOR COIN VENDOR SETUP.
4. (NO PROGRAM)
5. COUNTER MODE SETUP.
6. DESTINATION SETUP.
7. DRUM SENSITIVITY SETUP.
8. LCC EMPTY DATA SETUP.
When the sub code is entered, the LCD shows the following
display and the current set value is displayed on the copy
quantity display.
With the RPL on, select the code according to the sorter instal-
lation state and press the START key. Then the option setting
is stored.
SIMULATION NO. 26-1
SORTER/STAPLE SORTER SETTING?
1. YES
2. NO
SIMULATION NO. 26-1
OPTION SETUP.
CODE : RADF
SORTER/STAPLE SORTER
|
1
:
|
2
:
3
:
4
:
|: SETTING
PLEASE SELECT BY 10-KEY PAD.
9 – 20
|
|
: NO SETTING
Adjustment value
Ref. page
Adjustment
Default
scope
78 ∼ 179
128
P. 6 – 9
1 ∼ 4
2
P. 6 – 9
Advertisement
Table of Contents
