Adjust the position of the casters.
Caster nuts
Standard caster positon
Caster positoning plate
Loosen the caster nuts (4) and shift the caster positioning plates two
notches, as shown in the illustration.
Securing fixtures
Sorter protection mat
Caster nuts
Adjusted caster position
Remove all the securing tape (
materials (
) shown in the figures below.
Move dip switch to "ON."
Remove the 2 mounting screws securing the sorter control cover,
then remove the sorter control cover.
Next, move dip switch number 6 to the "ON" position (the dip
switches are attached to the sorter controller circuit board).
Reattach the sorter controller cover in its original position and secure
it with the 2 mounting screws.
6 – 21
) and securing