Table of Contents
Advertisement
Main
Sub
Item
code
code
4
TRC2H OFF timing
setting
Contents
LCD DISPLAY
COPY QUANTITY DISPLAY
*
* *
51A MFT (1~99)
* * *
51B CAS1 (1~99)
* * *
51C CAS2 (1~99)
* * *
51D CAS3 (1~99)
* * *
51E CAS4 (1~99)
* * *
51F LCC (1~99)
* * *
51 ADU (1~99)
Note 1: ( ) shows the input range of adjustment value.
Note 2: When the adjustment value is set to "0," the adjust-
ment is similar to that of the default value.
When the sub code is entered, the LCD shows the following
display and the currently set value of "51A" (TRC2H OFF
timing setting) is displayed on the copy quantity display. With
the RPL on, enter the set value with the 10-key pad and press
the START key to store it.
SIMULATION NO. 51-4
RRC PAPER BUCKLE ADJUSTMENT.
> 51A (1~99) :
46
[MFT]
51B (1~99)
: 46
[TRAY1]
51C (1~99)
: 46
[TRAY2]
51D (1~99)
: 46
[TRAY3]
51E (1~99)
: 46
[TRAY4]
51F (1~99)
: 46
[LCC]
51F (1~99)
: 46
[ADU]
Press the scroll key (→) to scroll the message display on the
LCD and the copy quantity display as follows:
51B → 51C → 51D → 51E → 51F → 51G → 51A →
The set value can be stored or changed in the same manner
as in "51A." The RRC front warp amount van be adjusted in
the range of 1 ∼ 99 for each tray. The greater the adjustment
value is, the greater the warp amount is, and vice versa. (1
count = 0.36mm; Default value = 46)
9 – 38
Default
: Manual feed tray
SCROLL KEY
ON
: Tray 1
SCROLL KEY
ON
: Tray 2
SCROLL KEY
ON
: Tray 3
SCROLL KEY
ON
: Tray 4
SCROLL KEY
ON
: LCC
SCROLL KEY
ON
: Intermediate tray
Adjustment value
Ref. page
Adjustment
scope
—
—
—
Advertisement
Table of Contents
