Table of Contents
Advertisement
4. Connect the ADF tray connector.
Open the ADF cover and connect the ADF connector to the tray
connector.
Connectors
ADF cover
5. Affach the tray.
Loosen the two mounting screws and secure the tray with the screws
as shown in the figure.
Close the ADF cover.
Mounting
screws
Plug the copier into a grounded outlet and turn the
power switch on.
Then, follow the procedure below.
6. Set the mode.
Operate the keys on the copier to set the mode.
2
C
The above key operation will display the
1
currently set mode.
OR
2
SIMULATION No. 26-1
SORTER/STAPLE SORTER SETTING?
1. YES 2. NO
Tray
1
6
SIMULATION NO. 26-1
OPTION SETUP.
CODE : RADF
SORTER/STAPLE SORTER
|
1
:
|
2
:
3
:
4
:
|: SETTING
PLEASE SELECT BY 10-KEY PAD.
7. Adjust the center of the copy.
Set the original on the tray and make a copy. When the copy slips out
of the center as Fig. 1 or Fig. 2, open the ADF cover, loosen the two
mounting screws and adjust the tray to correct position.
Mark
Fig. 1
Move the tray in the direction A and secure it with the two mount-
ing screws. Make sure that it is centered properly.
Fig.1
Center of copy (first copy)
Fig. 2
Move the tray in the direction B and secure it with the two mount-
ing screws. Make sure that it is centered properly.
Fig.2
Center of copy (first copy)
6 – 14
|
|
: NO SETTING
Mounting screw
Center of original
Center of original
Advertisement
Table of Contents
