Table of Contents
Advertisement
8. Removing the tray stopper as well as the securing
screw and the packing material which hold the paper
feed table in place.
The tray stopper is taped to the paper tray.
Remove the tape, and then remove the tray stopper.
For safekeeping of the tray stopper, slip it over the frame beneath the
slide lock as shown in the illustration.
Tape
Tray stopper
Remove the securing screw and the four pieces of packing material
which hold the large capacity tray's paper feed table in place.
Packing material
Paper feed table
Gently push the paper tray back in to its original position.
Slide lock
Tray stopper
Paper feed table
securing screw
Packing material
9. Setting modes and paper size
Set modes and paper size using the keys on the main copier unit.
0/
C
When the keys shown above are pressed in the indicated sequence,
the screen shown below will be displayed.
SIMULATION NO. 26
INPUT 1~7
1. OPTION SETUP.
2. LCC SETUP.
3. AUDITOR/COIN VENDOR SETUP.
4. (NO PROGRAM)
5. COUNTER MODE SETUP.
6. DESTINATION SETUP.
7. DRUM SENSITIVITY SETUP.
Press
2 , then
The LCC size options will appear in the message display.
SIMULATION NO. 26-2
SELECT LCC TYPE.
0. NC LCC
2. A4
3. B5
Press
1 , then
or
2
6 – 18
2
6
. The copier will enter LCC setup mode.
. This completes setting of modes and
paper size.
Advertisement
Table of Contents
