Sharp SF-2050 Service Manual page 41

Dip switches
Unplug the copier's power cord before carrying out
the following procedure.
A. Mounting of the staple sorter onto the copier.
1. Attach the sorter mounting plate.
Attach the sorter mounting plate with the 2 sorter mounting plate
screws (M4 x 16).
The sorter mounting plate screw holes are elongated; tighten the
screws so that the sorter mounting plate hangs down in its lowest
position.
Sorter mounting
plate screws
Sorter mounting plate
Mounting
screws
sorter control cover
Sorter control circuit board
2. Attach the support guide.
Attach the support guide by attaching its pawls (2 locations) to the
inside of the copier's paper output section.
3. Cut off the cut portions of the desk's left cabinet panel.
Remove the cut-outs (2) from the lower part of the copier's left
cabinet panel.
Cut portions
4. Attach the rail to the sorter.
Insert the rail into the rail mounting anchor, on the bottom of the
sorter, and attach them with the 2 rail screws A (M4 x 6) and 1 rail
screw B (M4 x 6).
Rail
Rail screws A
6 – 22
Pawls
Support guide
Rail mounting anchor
Rail screws B