Table of Contents
Advertisement
Main
Sub
Item
code
code
52
Contents
LCD DISPLAY
COPY QUANTITY DISPLAY
*
* *
51A MFT (1~99)
* * *
51B CAS1 (1~99)
* * *
51C CAS2 (1~99)
* * *
51D CAS3 (1~99)
* * *
51E CAS4 (1~99)
* * *
51F LCC (1~99)
* * *
51 ADU (1~99)
Note 1: ( ) shows the input range of adjustment value.
Note 2: When the adjustment value is set to "0," the adjust-
ment is similar to that of the default value.
When this simulation is executed, the machine goes into warm-
up state. At this time, the LCD shows the following message.
The correction value of RRC front warp quantity in manual
paper feed of small size paper is displayed on the copy quan-
tity display.
SIMULATION NO. 51-5
RRC PAPER BUCKLE REVISION.
(BYPASS TRAY;5.5×8.5, A5)
INPUT DATA. (0~20)
At this time, the correction value of RRC front warp quantity in
manual paper feed of small size paper can be entered
(changed). After entering the value, press the PROGRAM ON
key to store it.
When the warm up is completed, copying ca be made.
(Simulation No. 51)
When the sub code "6" is entered, the LCD shows the follow-
ing display. The currently set value (the correction value) of
RRC front warp amount in manual paper feed of small size
paper is displayed on the copy quantity display. When the RPL
is on, enter the correction value and press the PRINT switch to
store it.
SIMULATION NO. 51-6
RRC PAPER BUCKLE REVISION.
(BYPASS TRAY;5.5×8.5, A5)
INPUT DATA. (0~20)
When the main code is inputted, the LCD shows the following
display and a sub code blinks on the copy quantity display.
With the RPL on, enter the desired sub code and press the
START key to start the operation.
SIMULATION NO. 52
INPUT 1~2
1. DUPLEX WIDTH GUIDE ADJUSTMENT.
2. DUPLEX BACH STOP GUIDE ADJUSTMENT.
3. (NO PROGRAM)
4. ADU PAPER FEED TIMING
9 – 39
Default
: Manual feed tray
SCROLL KEY
ON
: Tray 1
SCROLL KEY
ON
: Tray 2
SCROLL KEY
ON
: Tray 3
SCROLL KEY
ON
: Tray 4
SCROLL KEY
ON
: LCC
SCROLL KEY
ON
: Intermediate tray
Adjustment value
Ref. page
Adjustment
scope
Advertisement
Table of Contents
