Main
Sub
Item
code
code
48
1
Front-rear direction
magnification ratio
adjustment
Contents
When the main code is inputted, the LCD shows the following
display and a sub code blinks on the copy quantity display.
With the RPL on, enter the desired sub code and press the
START key to start the operation.
SIMULATION NO. 48
INPUT 1~5
1. FRONT/REAR MAGNI ADJUSTMENT.
2. MAGNI RATIO FINE ADJUSTMENT.
3. LENS SPECIAL. (INPUT)
4. 4/5 MIRROR SPECIAL. (INPUT)
5. MAGNI RATIO FINE ADJUSTMENT. (INPUT)
When this simulation is executed, the machine starts warming
up.
At that time, the LCD shows the following display and "48A"
(Normal ratio correction data) is displayed on the copy quantity
display.
SIMULATION NO. 48-1
INPUT_A (26~66)
Use the 10-keypad to change the setting. After setting, press
the PROGRAM key to store the set value. Press the scroll key
( → ) to scroll the displays on the message display section on
the LCD and the copy quantity display as follows:
48B → 48C → 48D → 48E → 48F → 48A →
The set value can be stored in the same manner as in "48A."
After completion of warming up, copying is allowed.
LCD DISPLAY
COPY QUANTITY DISPLAY
*
* *
: Normal correction value [Default: 46]
INPUT_A (26~66)
SCROLL KEY
* * *
: Focus correction value (Reduction)[Default: 11]
INPUT_B (1~21)
SCROLL KEY
* * *
: Focus correction value (Enlargement)[Default: 11]
INPUT_C (1~21)
SCROLL KEY
* * *
: Focusing correction value[Default: 49]
INPUT_D (1~97)
SCROLL KEY
* * *
: Zoom correction value (Reduction)[Default: 11]
INPUT_E (1~21)
SCROLL KEY
* * *
: Zoom correction value (Enlargement)[Default: 11]
INPUT_F (1~21)
Note 1: ( ) shows the input range of adjustment value.
Note 2: When the adjustment value is "0," the similar adjust-
ment to the default value is performed.
9 – 30
Adjustment value
Default
—
ON
ON
ON
ON
ON
Ref. page
Adjustment
scope
—
—