1. Installation
1.4.2 Settingthe DIL switches
1
DIL switch 1.1 + 1.2:
bus node operating mode
2
DIL switches 2.1 + 2.2:
diagnostics mode (only in remote I/O operating
mode);
data field size (only in remote controller
operating mode)
3
Memory card
(see section 1.4.3, 1.5 as well as 2.6.3 and 2.8.1)
Fig. 1/3: Settings of the DIL switches in the bus node
1-8
You can set the following parameters with the DIL switches
under the cover (see Fig. 1/3):
–
bus node operating mode
–
diagnostics mode (remote I/O operating mode only)
–
data field size (only in remote controller operating mode).
Approach:
1. Switch off the power supply.
2. Remove the cover (see section 1.4.1).
3. Carry out the required settings
(see Tab. 1/1, Tab. 1/2 and Tab. 1/4).
4. Install the cover again
(see section 1.4.1).
Note
Make sure that the seal is seated correctly.
•
1
Festo P.BE-CPX-PNIO-EN en 1407c English
2
3