2. Commissioning
2-50
Note – System start in the operating mode FSU
For the system start, the function "System Start with Saved
Parameters" ("Saved" or "Stored" parameters) must be
activated to ensure that the parameters entered using FMT
or MMI are used.
This setting must be made at two positions:
– in the bus node system parameters (using FMT or MMI)
– in the system parameters of the control software
(e.g. Siemens STEP 7, see 1 in Fig. 2/13).
1
Fig. 2/13: System start in the operating mode FSU – "System
Start with Saved Parameters" ("Saved" or "Stored
Parameters")
Festo P.BE-CPX-PNIO-EN en 1407c English