1. Installation
1.4.3 Using the memory card
Replacing
the memory card
1-14
The memory card is used as a carrier of configuration data for
PROFINET addressing and thus simplifies bus node replace-
ment:
–
PROFINET I/O device name
–
IP address.
Note
Data stored on the card have priority over other configura-
tion data which are stored, e.g. in the bus node memory or
in the controller system (see also section 2.8.1, sequence
of the start parameterisation with memory card).
Caution
Risk of malfunctions or damage.
Inserting or removing the memory card while the power
supply is switched on can result in malfunctions of or dam-
age to the memory card.
Disconnect the power supply before you insert or
•
remove the memory card.
The memory card is under a cover (see Fig. 1/1). You need a
screwdriver in order to remove or attach this cover.
Festo P.BE-CPX-PNIO-EN en 1407c English