Festo CPX-FB33 Manual page 85

2. Commissioning
Festo P.BE-CPX-PNIO-EN en 1407c English
10. Make sure that the following values are set for "IO Cycle":
Update time 2:
–
– Mode:
– Update time:
Address monitoring time 3:
–
– Number of update cycles:
– Address monitoring time:
11. Confirm your inputs by clicking on "OK".
12. Click on the symbol of the CPX terminal to be configured
in the PROFINET Hardware Configuration (HW Config, 3
in Fig. 2/2).
13. The configuration table is displayed:
You will find the configuration table below the schematic
representation of the PROFINET-IO system. If necessary,
increase the size of this area of the HW Config window
(see Fig. 2/2 or 2 in Fig. 2/11).
14. Double click in the configuration line of the connection
(port) "X1 TP1".
The window "Properties – CPX FSU Port 1" (X1 TP1) is
displayed (see Fig. 2/7).
fixed
Update time
1,000 ms
3
3,000 ms
2-37