1. Installation
1.2
Settings of the DIL switches on the field bus node
1.2.1 Removing and fitting the cover over the DIL switches
Removing
Fitting
1.2.2 Setting the DIL switches
en 0206NH
Festo P.BE-CPX-FB14-GB
In order to set the CPX field bus node you must first remove
the cover over the DIL switches.
1. Switch off the power supply.
2. Unscrew the two fastening screws in the switch cover.
3. Lift up the cover.
1. Place the cover carefully on the node.
Please note
Make sure that the seal is seated correctly.
•
2. Tighten the two fastening screws at first by hand and then
with torque 0.5 ... 0.8 Nm.
When you have removed the cover for the DIL switches, you
will see five DIL switches in the field bus node (see Fig. 1/3).
You can set the following parameters with the DIL switches:
–
Fault mode
–
Station number
–
Baud rate
–
CPX diagnostic mode.
1-7