Contents and general safety instructions
Intended use
Festo P.BE-CPX-PNIO-EN en 1407c English
The bus nodes documented in this description, CPX-FB33,
CPX-M-FB34 and CPX-M-FB35, are intended only for use as
participants (I/O device) on the Industrial Ethernet system
PROFINET IO.
The bus nodes can be used in three different operating
modes:
–
Remote I/O
–
Remote controller
–
Remote I/O with additional function "Prioritized Start-
up", also designated "Fast Start-up" (FSU) or "Fast re-
start".
"Fast Start-up" ensures a faster running up of the CPX termin-
al.
But this additional function has restrictions regarding com-
missioning and parameterisation
The CPX terminal must only be used as follows:
–
as intended in industrial environments;
outside of industrial environments, e.g. in commercial and
mixed-residential areas, actions to suppress interference
may have to be taken
–
exclusively in combination with modules and components
that are permissible for the respective product variant of
the CPX terminals
–
in original status without unauthorised modifications;
only the conversions or modifications described in the
documentation supplied with the product are permitted
–
in perfect technical condition.
Section B.1.3.
www.festo.com/catalogue
VII