Cpx-Terminal Configuration; Allocate Configuration Table (Insert Bus Nodes And Modules) - Festo CPX-FB33 Manual

2. Commissioning
2.7

CPX-terminal configuration

2.7.1 Allocate configuration table (insert bus nodes and modules)

Festo P.BE-CPX-PNIO-EN en 1407c English
In the subsequent steps, you take the bus node and individu-
al modules of your CPX terminal ( 1 in Fig. 2/11) from the
hardware catalogue into the configuration table ( 2 ).
The CPX modules are subdivided within the hardware cata-
logue into field-device groups ( 4 in Fig. 2/11): analogue
modules, digital modules, pneumatic interfaces, pneumatic
modules and technology modules. The bus nodes CPX-FB33,
CPX-M-FB34 and CPX-M-FB35 form their own group in this
environment ("Bus nodes").
The field-device groups or "Bus node and module folder" are
located under the station symbols ( 3 ).
1. Start the PROFINET hardware configuration in your config-
uration and programming software (e.g. HW Config in
Siemens STEP 7).
2. If the Hardware Catalogue has not been opened:
Click on the catalogue symbol or use the keyboard com-
bination [Ctrl] + [K].
The hardware catalogue is displayed.
3. In the Hardware Catalogue, open the folder:
– "\PROFINET-IO\Additional Field Devices\Valves\Festo
CPX-Terminal" (English language version of the soft-
ware)
or
– \PROFINET-IO\Weitere Feldgeräte\Ventile\Festo CPX-
Terminal.
2-43