Festo CPX-FB33 Manual page 102

2. Commissioning
1
Fig. 2/15: Setting module parameters with Siemens STEP 7
2-54
Setting module parameters
1. Start the PROFINET hardware configuration in your config-
uration and programming software (e.g. HW Config in
Siemens STEP 7).
3
2. Double click in the configuration table on the description
of the module you would like to parameterise (1 in
Fig. 2/15). The "Properties ..." dialogue window is dis-
played.
3. Click on the parameter value ("Value") which you wish to
modify. A list with the possible values will be opened 2.
Festo P.BE-CPX-PNIO-EN en 1407c English
2