Modify I/O Address; Modify Diagnostics Address - Festo CPX-FB33 Manual

2. Commissioning

2.7.2 Modify I/O address

2.7.3 Modify diagnostics address

Festo P.BE-CPX-PNIO-EN en 1407c English
Note
The DIL switch settings for operating mode and dia-
gnostics mode must match the bus node selection in the
context of a PLC hardware and network configuration (see
Tab. 1/3 and section 2.6.2).
Check the setting of the DIL switches for operating mode
•
and diagnostics mode (see section 1.4.2): Make sure
that the setting for operating mode and diagnostics
mode selected on the bus node via DIL switch agrees
with the function of the catalogue element.
1. Double click on the module name in the configuration
table.
The "Properties – ..." window is displayed.
2. Select the "Addresses" tab.
3. Change the start address ("Start") of the inputs or out-
puts.
4. Confirm the input with "OK".
The modified address is displayed in the configuration
table.
The diagnostics address is automatically assigned by the
Siemens STEP 7 configuration and programming software -
HW Config. A change is rarely required.
1. Double-click on "Slot 0" in the configuration table.
The "Properties – CPX" window is displayed
(see Fig. 2/12).
2-47