1. Installation
1.2.2 Settingthe DIL switches
1
DIL switch 1:
Bus node operating
mode
2
DIL switch 2
only for operating
mode Remote I/O:
Diagnostic mode
Fig. 1/3: Settings of the DIL switches on the bus node
1−8
You can set the following parameters with the DIL switches
under the cover (see Fig. 1/3):
Bus node operating mode
Diagnostic mode
Procedure
1. Switch off the power supply.
2. Remove the cover (see section 1.2.1).
3. Make the required settings (see Tab. 1/1 and Tab. 1/2).
4. Replace the cover (see section 1.2.1).
1
Festo P.BE−CPX−PN IO−EN en 0710NH
2