1. Installation
2
DIL switch
DIL 2.1:
DIL 2.2:
(factory setting)
DIL 2.1:
DIL 2.2:
DIL 2.1:
DIL 2.2:
DIL 2.1:
DIL 2.2:
Tab. 1/4:
Setting the data field size with DIL switch
Festo P.BE-CPX-PNIO-EN en 1407c English
In the remote controller operating mode:
setting the data field size with DIL switch
The function of the DIL switch
the DIL switch
minal (
Tab. 1/1):
The required data field size is set with DIL switch
remote controller operating mode (
Note
Observe that the data field size set with the DIL switch 2
(
Tab. 1/4) must be the same size or larger than the data
field size, which you set in your control system.
Further explanations about the remote controller operating
mode can be found in section 2.10 and B.1.2.
Set data field size
(in the remote controller operating mode)
OFF
Maximum data field size:
OFF
8 bytes I/8 bytes O
OFF
Maximum data field size:
ON
16 bytes I/16 bytes O
ON
Reserved for future extensions
OFF
ON
Reserved for future extensions
ON
2
depends on the setting of
1
or the set operating mode of the CPX ter-
2
2
2
in the
Tab. 1/4).
1-13