Festo CPX-FB33 Manual page 79

2. Commissioning
Select "Station"
(station symbol)
Festo P.BE-CPX-PNIO-EN en 1407c English
3. In the Hardware Catalogue (HW Config), open the folder:
– \PROFINET-IO\Weitere Feldgeräte\Ventile\Festo CPX-Ter-
minal (German language version of the software)
– "\PROFINET-IO\Additional Field Devices\Valves\Festo
CPX-Terminal" (English language version of the software)
Note
If the folder "Valves\Festo CPX-Terminal" is not displayed
(see Fig. 2/3), repeat installation of the device master file
(GSDML, see section 2.5.5).
Fig. 2/3: Station selection – selection of the station symbol
(Festo CPX terminals)
4. Choose the station symbol corresponding to your applica-
tion using the following Tab. 2/11 – dependent on:
– CPX revision code of the bus node
(see section 2.5.2 or Tab. 2/10)
– operating mode of the bus node
(see section 1.4.2 or Tab. 1/1)
– additional function "Fast Start-up"
(FSU) see section B.1.3)
– Connection technology (M12 or RJ45 or SCRJ).
2-31