2. Commissioning
3
2.6.5 Assigning or changing IP address
Assigning or changing
IP address
Festo P.BE-CPX-PNIO-EN en 1407c English
17. Deactivate crossover detection 3:
Place a check in front of "Deactivate Autonegotiation/
Autocrossover" (Disable Autonegotiation).
18. Also deactivate crossover detection in the counterpart
station, e.g. in the control system (PLC/Master).
Deactivation of crossover detection is required for "Fast start-
up". These additional functions are possible only with cros-
sover detection deactivated.
19. Use a suitable network cable for this connection, in this
case a crossed line, for example (if the crossover detec-
tion is deactivated on both sides of the connection and a
connection between PLC or master and slave is created).
20. Repeat the steps 14. to 19. for port X2 TP2.
You can manually assign or change the IP address of the CPX
terminal in the next steps. The controller usually takes over
the allocation of an IP address (automatic addressing using
the DHCP server integrated in the controller).
If you would like to accept the specified IP address, you can
skip the steps 21. to 23..
21. For IP addressing, choose the tab "Addresses" ( 1 in
Fig. 2/8).
The "Addresses" tab is displayed (see Fig. 2/9).
2-39