Festo CPX-FB33 Manual page 27

1. Installation
1
DIL switch
DIL 1.1:
DIL 1.2:
(Factory setting)
DIL 1.1:
DIL 1.2:
Tab. 1/1: Setting the bus node operating mode with DIL switch
Festo P.BE-CPX-PNIO-EN en 1407c English
Setting the operating mode with DIL switch
You can set the operating mode of the bus node with switch
element 1.1 of DIL switch
– remote I/O operating mode
– remote controller operating mode.
Set bus node operating mode
Remote I/O operating mode
OFF
OFF
All functions of the CPX terminal are controlled directly by the
PROFINET-I/O controller or a higher-level PLC.
The bus node undertakes the required connection to PROFINET.
ON Operating mode Remote Controller
OFF
Requirement:
A control block CPX-FEC or CPX-CEC is a component of the CPX
terminal.
The CPX-FEC or CPX-CEC control block integrated into the terminal
controls all functions of the CPX terminal, i.e. the control block takes
on the I/O control.
The bus node takes over the additional connection to PROFINET.
Further explanations of the bus node operating mode can be
found in section B.1:
– remote I/O operating mode
– remote controller operating mode
– additional function "Fast Start-up" (FSU)
1
1
(see Tab. 1/1):
1
Section B.1.1
Section B.1.2
Section B.1.3.
1-9