Hardware Requirements; Operating Systems; Installation Under Windows - Kollmorgen SERVOSTAR 300 Instruction Manual

Kollmorgen
9.2.3

Hardware requirements

The PC interface (X6, RS232) of the servo amplifier is connected to the serial interface of
the PC by a null-modem cable (not a null-modem link cable!) (ð p.95).
Connect / disconnect the interface cable only when the electrical supply is switched off for
both the PC and the servo amplifier.
The interface in the servo amplifier has the same potential level as the CANopen inter-
face.
Minimum requirements for the PC:
9.2.4

Operating systems

WINDOWS 2000 / XP / Vista / 7 / 8 / 10
DRIVEGUI.EXE will run under WINDOWS 2000, XP, Vista, 7, 8 and 10.
Emergency operation is feasible through an ASCII terminal emulation (without graphical
user interface).
Interface settings : 38400 bps, databit 8, no parity, stopbit 1, no flow control
Unix, Linux
The functioning of the software has not been tested for WINDOWS running within Unix or
Linux.
9.2.5

Installation under WINDOWS

The CD-ROM includes an installation program for the setup software.
Installation
Autostart function activated:
Insert the CD-ROM into a free drive. A window with the start screen opens. There you
find a link to the setup software DRIVEGUI.EXE. Click it and follow the instructions.
Autostart function deactivated:
Insert the CD-ROM into a free drive. Click on START (task bar), then on Run. Enter the
program call: x:\index.htm (x = correct CD drive letter).
Click OK and proceed as described above.
Connection to the serial interface of the PC:
Connect the interface cable to a serial interface on your PC (COM1 to COM10) and to the
serial interface of the servo amplifier S300 (ð p.95).
S300 Instructions Manual
Processor :
Operating system :
Graphics adapter :
Drives :
Interface :
02/2017
®
at least Pentium II or comparable
WINDOWS 2000 / XP
Windows compatible, color
hard disk with at least 10 MB free space
CD-ROM drive
one free serial interface (COM1 ... COM10)
Setup
99