Hardware Requirements, Operating Systems; Installation Under Windows - Kollmorgen S700 Series Instruction Manual

S748-772 Instructions Manual | 10 Setup

10.2.3 Hardware requirements, operating systems

The PC interface (X6, RS232) of the servo amplifier is connected to the serial interface of
the PC by a null-modem cable (not a null-modem link cable!) (➜ # 104).
Connect or disconnect the interface cable only when the electrical supply is switched off for
both the PC and the servo amplifier.
The interface in the servo amplifier has the same potential level as the CANopen interface.
Minimum requirements for the PC:
Processor:
Graphics adapter:
Drives:
Interface:
Operating systems WINDOWS 2000, XP, VISTA, 7 / 8 / 10
DRIVEGUI.EXE will run under WINDOWS 2000, XP, VISTA, 7, 8 and 10.
Emergency operation is feasible through an ASCII terminal emulation (without graphical user
interface).
Interface settings : 38400 bps, databit 8, no parity, stopbit 1, no flow control
Operating systems Unix, Linux
The functioning of the software has not been tested for WINDOWS running within Unix or
Linux.

10.2.4 Installation under WINDOWS

The CD-ROM includes an installation program for the setup software.
Installation
Autostart function activated:
Insert the CD-ROM into a free drive. A window with the start screen opens. There you find a
link to the setup software DRIVEGUI.EXE. Click it and follow the instructions.
Autostart function deactivated:
Insert the CD-ROM into a free drive. Click on START (task bar), then on Run. Enter the pro-
gram call: x:\index.htm (x = correct CD drive letter).
Click OK and proceed as described above.
Connection to the serial interface of the PC:
Connect the interface cable to a serial interface on your PC (COM1 to COM10) and to the
serial interface of the servo amplifier S700 (➜ # 104).
110 Kollmorgen | kdn.kollmorgen.com | July 2019
At least Pentium® II or comparable
Windows compatible, color
Hard disk with at least 10 MB free space
CD-ROM drive
one free serial interface (COM1 ... COM10) or USB with an USB-
>Serial converter