Table of Contents
Advertisement
Danaher Motion
Hardware Installation
UNPACKING AND INSPECTION
Electronic components in this amplifier are design hardened to reduce static sensitivity.
However, proper procedures should be used when handling.
Remove all packing material and equipment from the shipping container. Be aware that some
connector kits and other equipment pieces may be quite small and can be accidentally
discarded if care is not observed when unpacking the equipment. Do not dispose of shipping
materials until the packing list has been checked.
Upon receipt of the equipment, inspect components to ensure that no damage has occurred in
shipment. If damage is detected, notify the carrier immediately. Check all shipping material
for connector kits, manuals, diskettes, and other small pieces of equipment.
MOUNTING
For proper ventilation the SERVOSTAR and BUS module units should be mounted vertically. No
horizontal distance between the drive and BUS module is required. In systems using more than two
SERVOSTARs per BUS module, divide the drives equally on either side of the BUS module. They are
designed for mounting in an electrical enclosure to protect them from physical and environmental damage
and to protect nearby personal from hazardous electrical potentials.
®
SERVOSTAR
SBD-Series ST/CT Product Family
Hardware Installation
15
Advertisement
Table of Contents
