Ec Conformance; European Directives And Standards For The Machine Builder - Kollmorgen SERVOSTAR 300 Instruction Manual

Approvals
4.2

EC Conformance

The servo amplifiers have been tested by an authorized testing laboratory in a defined
configuration, using the system components that are described in this documentation.
Any divergence from the configuration and installation described in this documentation
means that you will be responsible for carrying out new measurements to ensure confor-
mance with regulatory requirements.
Kollmorgen declares the conformity of the product SERVOSTAR 300 (S300) with the fol-
lowing directives:
l
l
l
The servo amplifier meets the noise immunity requirements to the 2nd environmental cat-
egory (industrial environment). For noise emission the amplifier meets the requirement to
a product of the category C2 (motor cable £ 10m). With a motor cable length of 10m or
longer, the servo amplifier meets the requirement to the category C3.
This product can cause high-frequency interferences in non industrial environments
which can require measures for interference suppression.
4.2.1

European Directives and Standards for the machine builder

Servo amplifiers are safety components that are intended to be incorporated into electri-
cal plant and machines for industrial use. When the servo amplifiers are built into
machines or plant, the amplifier must not be used until it has been established that the
machine or equipment fulfills the requirements of the
l
l
l
Standards to be applied for conformance with the EC Machinery Directive (2006/42/EC)
EN 60204-1
EN 12100
The manufacturer of the machine must generate a risk assessment for the machine, and
must implement appropriate measures to ensure that unforeseen movements cannot
cause injury or damage to any person or property.
The machine/plant manufacturer must check whether other standards or EC Directives
must be applied to the machine/plant.
Standards to be applied for conformance with the Low Voltage Directive (2014/35/EC):
EN 60204-1
EN 60439-1
Standards to be applied for conformance with the EMC Directive (2014/30/EC):
EN 61000-6-1 / 2 (Interference Immunity in Residential & Industrial Areas)
EN 61000-6-3 / 4 (Interference Generation in Residential & Industrial Areas)
The manufacturer of the machine/plant is responsible for ensuring that it meets the limits
required by the EMC regulations. Advice on the correct installation for EMC can be found
in this documentation.
We only guarantee the conformance of the servo system with the standards cited in this
chapter if the components (motor, cables, chokes etc.) are those supplied by us.
18
EC Machinery Directive
EC EMC Directive
EC Low Voltage Directive
EC Machinery Directive
EC EMC Directive
EC Low Voltage Directive
(Safety and Electrical Equipment in Machines)
(Safety of Machines)
(Safety and Electrical Equipment in Machines)
(Low-voltage switchgear and controlgear assemblies)
02/2017
(2006/42/EC)
(2014/30/EC)
(2014/35/EC)
(2006/42/EC)
(2014/30/EC)
(2014/35/EC)
Kollmorgen
S300 Instructions Manual