Figure 40: Installing The Wall-Mounting Kit - Juniper ACX500 Hardware Manual

ACX500 Universal Access Router Hardware Guide
114
NOTE: The router must be mounted keeping in mind the basic clearance
requirement for the ACX500 outdoor router. See
for Airflow and Hardware Maintenance on ACX500 Routers" on page 61
for more information.
Remove the bracket, and drill four holes at the points marked on the wall.
4.
Install mounting screws (to anchor the router) into the top two drill holes until you
5.
have 1/4 in. of the screws left.
NOTE:
The mounting screws are not provided. The size and strength of the
mounting screws must safely support the total weight of the router
chassis, including the mounting brackets and cables, and must comply
with the local standards and practices.
It is important to leave 1/4 in. of the screw. The keyholes on the
wall-mounting bracket align with these screws and help hang the
wall-mounting kit on the wall.
Carefully align the wall-mounting bracket keyholes of the joined brackets and hang
6.
it on the two screws that were secured on the wall in step 5. See

Figure 40: Installing the Wall-Mounting Kit

1— Wall-mounting bracket keyhole
2— Chassis-mounting bracket keyhole
Pull the wall-mounting kit gently down so that it sits tightly on the screws.
7.
Insert two mounting screws onto the bottom wall-mounting holes to completely
8.
secure the wall-mounting kit to the wall.
"Clearance Requirements
Figure 40 on page
3— Chassis-mounting bracket
4— Wall-mounting bracket
Copyright © 2016, Juniper Networks, Inc.
114.