Juniper ACX500 Hardware Manual page 137

Copyright © 2016, Juniper Networks, Inc.
You can mount the ACX500 outdoor router on a pole with the help of a pole-mounting
kit. The ACX500 pole-mounting kit consists of two mounting brackets (one is attached
to the rear of the ACX500 outdoor router and the other to the pole), 5/8-in. through bolts,
and pole straps.
The ACX500 outdoor router meets the requirement of the International Protection Code
(IP65) for dust-tight environments and ingress of water jets.
The pole on which you want to install the ACX500 outdoor router along with the
pole-mounting kit must satisfy the following requirements:
When installing the ACX500 outdoor router on a pole, the chassis must be installed
in a vertical orientation with the cables pointing downward and the eye bolt for hoisting
the router pointing upward.
The strength and thickness of the pole must safely support the total weight of the
router chassis, including the mounting brackets and cables, and must comply with
local standards and practices.
The pole must be able to support the weight of the fully configured router (router
chassis and mounting kit).
The AC-powered ACX500 outdoor router weighs 18.2 lb (8.3 kg), and the DC-powered
weighs 17.5 lb (7.9 kg). AC-powered ACX500 outdoor router with PoE weighs 18.7 lb
(8.5 kg), and the DC-powered router weighs 18.6 lb (8.4 kg). The pole-mounting kit
weighs 2.8 lb (1.3 kg).
Ensure that the pole is stable and securely supported.
The width of the pole must be within the range of 2 in. through 16 in. to hold the
pole-mounting kit.
To mount the router, use the pole-mounting kit from Juniper Networks.
Ensure that you have the following parts and tools available:
Phillips (+) screwdriver with a minimum shaft length of 6 in. (150 mm)
3/8 in. ratchet driver set
An electrostatic discharge (ESD) grounding strap
Pole-mounting kit (to be purchased separately)
Ground label and ground lug provided with the pole-mounting kit
To mount the ACX500 outdoor router on a pole:
Attach an ESD grounding strap to your bare wrist, and connect the strap to one of the
1.
ESD points on the chassis.
Align and attach the chassis-mounting bracket and the pole-mounting bracket
2.
provided with the pole-mounting kit, and secure the two brackets with the set of four
bracket screws, washers, and nuts. See
Chapter 12: Installing the ACX500 Router
Figure 42 on page 118.
117