Juniper ACX500 Hardware Manual page 132

ACX500 Universal Access Router Hardware Guide
112
You can mount the ACX500 outdoor router on the wall with the help of a wall-mounting
kit. The ACX500 wall-mounting kit consists of two mounting brackets (one is attached
to the rear of the ACX500 outdoor router and the other to the wall).
The ACX500 outdoor router meets the requirement of the International Protection Code
(IP65) for dust-tight environments and ingress of water jets.
The wall on which you want to install the ACX500 outdoor router along with the
wall-mounting kit must have the following:
When installing the ACX500 outdoor routers on a wall, the chassis must be installed
in a vertical orientation with the cables pointing downward and the eye bolt for hoisting
the router pointing upward.
The strength and thickness of the wall must safely support the total weight of the
router chassis, including the mounting brackets and cables, and must comply with
local standards and practices.
The wall must be able to support the weight of the fully configured router (router
chassis and mounting kit).
The AC-powered ACX500 outdoor router weighs 18.2 lb (8.3 kg), and the DC-powered
router weighs 17.5 lb (7.9 kg). The AC-powered ACX500 outdoor router with PoE weighs
18.7 lb (8.5 kg), and the DC-powered router with PoE weighs 18.6 lb (8.4 kg). The
wall-mounting kit weighs 2.8 lb (1.3 kg).
When choosing a location, allow at least 6 in. (15.2 cm) of clearance between the sides
of the chassis (with the router in the installed position) and adjacent equipment or
walls.
Ensure that the wall is stable and securely supported.
If you are mounting the router in wallboard with a gypsum plaster core or in wallboard
not backed by wall studs, use hollow wall anchors capable of supporting the combined
weight of two fully loaded chassis. Insert the screws into wall studs wherever possible
to provide added support for the chassis.
To mount the router, use the wall-mounting kit from Juniper Networks.
The wall-mounting kit is not part of the standard package and must be ordered
separately.
For service personnel to remove and install hardware components, allow at least 24 in.
(60.9 cm) on top of the router.
Ensure that you have the following parts and tools available:
Phillips (+) screwdriver with a minimum shaft length of 6 in. (150 mm)
3/8 in. ratchet driver set
An electrostatic discharge (ESD) grounding strap
Wall-mounting kit (to be purchased separately)
Based on the wall type, appropriate screws to secure the wall-mounting bracket on
the wall (not provided)
Copyright © 2016, Juniper Networks, Inc.