Juniper ACX500 Hardware Manual page 82

ACX500 Universal Access Router Hardware Guide
ACX500 Outdoor Router Chassis Dimensions and Clearance Requirements
62
Prepare your site for installation by observing the following guidelines:
When installing the ACX500 outdoor routers on a pole or on a wall, the chassis must
be installed in a vertical orientation with the cables pointing downward and the eye
bolt for hoisting the router pointing upward.
Figure 26 on page 63 and
outdoor router after installation.
When choosing a location, allow at least 6 in. (15.2 cm) of clearance between the sides
of the chassis (with the router in installed position) and adjacent equipment or walls.
See Figure 26 on page 63.
Ensure that the wall or the pole onto which the router is installed is stable and securely
supported.
Ensure that the wall or pole is able to carry the load of the fully configured router.
If you are mounting the router in wallboard with a gypsum plaster core or in wallboard
not backed by wall studs, use hollow wall anchors capable of supporting the combined
weight of two fully loaded chassis. Insert the screws into wall studs wherever possible
to provide added support for the chassis.
The width of the pole must be within the range of 2 in. through 16 in. for the
pole-mounting brackets to fit properly.
To mount the router, use the pole-mounting kit or the wall-mounting kit from Juniper
Networks.
One person must be available to lift the router while another secures the router.
For service personnel to remove and install hardware components, allow at least 24 in.
(60.9 cm) on top of the router. See
Figure 27 on page 64 show the orientation of the ACX500
Figure 27 on page 64.
Copyright © 2016, Juniper Networks, Inc.