Figure 50: Acx500 Outdoor Router Cable Connector Unit - Juniper ACX500 Hardware Manual

Copyright © 2016, Juniper Networks, Inc.

Figure 50: ACX500 Outdoor Router Cable Connector Unit

1— Connector enclosure
2— Interface SFP cable
Push the connector screw back on top of the cable seal until the whole unit fits tightly.
9.
Tighten the connector screw's thread end along with the cable seal inside it back into
10.
the connector enclosure port on the router. See
Pull the cable with a torque of 16 lb-in. (1.8 Nm) to ensure that the cable sits tightly
inside the cable connector unit. Also, visually examine the cable and the groove to
ensure that there is no gap left, and that the cable sits properly in the groove.
Chapter 12: Installing the ACX500 Router
3— Cable seal
4— Connector screw
Figure 51 on page 128.
127