Figure 62: Power Terminal Location On The Acx500 Outdoor Router; Figure 63: Ac Power Cord Wires That Connect To The Power Source - Juniper ACX500 Hardware Manual

ACX500 Universal Access Router Hardware Guide
144

Figure 62: Power Terminal Location on the ACX500 Outdoor Router

1— Interface port chamber with weather seal
cover
2— Cable connector ports with weather seal
cap
Power off the AC power source.
4.
NOTE: Ensure that the power source for the ACX500 outdoor router is off
before connecting or disconnecting the power cord wires from the power
source.
Insert the appliance coupler terminal end of the power cord into the appliance inlet
5.
on the power source. Ensure that the power cord terminal is connected properly.
One end of the AC power cord for the ACX500 outdoor router has the AC power plug
(see Figure 64 on page
power cord wires (see Figure 63 on page

Figure 63: AC Power Cord Wires That Connect to the Power Source

1— Power lug
2— Label (G, N and L)
3— Management port chamber with weather
seal cover
4— Power port with weather seal cap
145) that connects to the router, and the other end has three
144) that are connected to the power source.
3— Cord wire
4— AC power cord
Copyright © 2016, Juniper Networks, Inc.