Figure 47: Removing The Acx500 Outdoor Router Cable Connector Unit - Juniper ACX500 Hardware Manual

ACX500 Universal Access Router Hardware Guide
124
Unscrew and remove the corresponding cable connector unit from the cable inlet
3.
port. See Figure 47 on page
The cable connector unit consists of three components—the outer connector enclosure,
the connector screw, and the cable seal. The front end of the outer cable connector
enclosure is from where the interface cable enters the router, and the rear end with
screw thread connects directly to the chassis cable port on the router. The connector
screw houses a rubber cable seal, and screws fit tightly in the cable connector
enclosure. The cable seal is a small cylindrical rubber structure with grooves or holes
for the cables to pass through. The cable seal sits tightly in the connector screw and
prevents water and dust particles from entering the router.
NOTE: The cable seal with single groove must be used for the SFP cables,
and that with three grooves must be used for the RJ-45 cables.

Figure 47: Removing the ACX500 Outdoor Router Cable Connector Unit

Carefully align the transceiver with the cable inlet hole of the SFP port where you want
4.
to insert the interface cable, and slide the transceiver until the connector is seated in
the corresponding port. See
124.
Figure 48 on page 125.
Copyright © 2016, Juniper Networks, Inc.