ACX500 Universal Access Router Hardware Guide
Connecting the Router to a Network for Out-of-Band Management
Connecting the Router to a Management Console
152
To connect to the
MGMT
port on the ACX500 router:
Turn off the power to the management device.
1.
Plug one end of the Ethernet cable into the
2.
(Figure 67 on page 152
Plug the other end of the cable into the network device.
3.
Figure 67: Ethernet Cable Connector
Figure 68: Ethernet Port
CONSOLE/AUX
port
You can connect a console, laptop, or modem by connecting a serial cable to the port
on the front panel labeled
MGMT
which is provided with the router.
To connect a management console:
Turn off the power to the console.
1.
Plug the RJ-45 end of the serial cable into the
2.
(Figure 69 on page 153
Plug the female DB-9 end into the device's serial port.
3.
NOTE:
For console devices, configure the serial port to the following values:
Bits per second—9600
Data bits—8
Parity—None
Stop bits—1
Flow control—None
MGMT
shows the connector.
Figure 68 on page 152
Console Server
. This port accepts a serial cable with an RJ-45 connector,
MGMT
shows the connector.
Figure 70 on page 153
port on the router.
shows the port.)
PC
port on the front panel
shows the ports.)
Copyright © 2016, Juniper Networks, Inc.