Juniper ACX500 Hardware Manual page 163

Copyright © 2016, Juniper Networks, Inc.
AC power cord for the ACX500 outdoor router (not provided, must be purchased
separately)
NOTE: Use the power cord that is purchased from Juniper Networks, and is
compatible with the ACX500 outdoor router. Using a power cord other than
that is provided by Juniper Networks with the router can damage the power
terminal. These power cords are specifically designed to be used only with
the specified ACX500 outdoor routers.
WARNING: You must ground the router before connecting the power cables.
NOTE: For disconnecting power to the router, first remove or switch off the
power to the power cord by opening the circuit breaker or suitable service
disconnect at the AC disconnect box or power distribution unit (PDU). Then
rotate the power cord connector ring to disconnect the power cord from the
router connector. Doing this ensures that the power cord is safe to handle.
To connect AC power to the router:
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Locate the power cord that is compatible with the ACX500 outdoor router.
2.
Power cords for the ACX500 outdoor routers are not shipped with the router. The
power cords are specifically designed to be used only with the specified ACX500
outdoor routers. The unique design of these power cords help to protect the power
terminal from the external environmental factors, such as water and dust.
Remove the screw cover cap protecting the power terminal on the faceplate.
3.
Figure 62 on page 144 shows the location of the power terminal.
Chapter 14: Providing Power to the ACX500
143