Figure 39: Wall-Mounting Kit - Juniper ACX500 Hardware Manual

Copyright © 2016, Juniper Networks, Inc.
Ground label and ground lug provided with the wall-mounting kit
Marker pen
Drilling machine
To mount the ACX500 outdoor router on a wall:
Attach an ESD grounding strap to your bare wrist, and connect the strap to one of the
1.
ESD points on the chassis.
Align and attach the chassis-mounting bracket and the wall-mounting bracket provided
2.
with the wall-mounting kit, and secure the two brackets with the set of four bracket
screws, washers, and nuts. See
NOTE: Apply between 50 lb-in. (5.7 Nm) and 60 lb-in. (6.8 Nm) of torque
on the screws to ensure that both the brackets are held tightly.

Figure 39: Wall-Mounting Kit

1— Screw
2— Split washer
3— Chassis-mounting bracket
Place the joined brackets on the wall where you want to install the outdoor router
3.
with the wall-mounting bracket facing the wall, and mark the four wall-mounting
screw hole points on the wall.
Chapter 12: Installing the ACX500 Router
Figure 39 on page 113.
4— Wall-mounting bracket
5— Flat washer
6— Nut
113