Figure 53: Removing The Cable Connector Unit - Juniper ACX500 Hardware Manual

ACX500 Universal Access Router Hardware Guide
130

Figure 53: Removing the Cable Connector Unit

Remove the cable seal from the cable connector unit (also known as cable gland
4.
unit) by loosening the connector screw and pushing the cable seal out. See
Figure 54 on page 131. Keep the cable seal and the cable connector unit for later use.
Pass the interface cable through the front end of the outer cable connector enclosure.
5.
NOTE: Ensure that you use an outdoor installation rated and
IP65-compliant waterproof fiber-optic cable with an outer diameter of
10 mm for the SFP ports, and that with an outer diameter of 6.5 mm for
the RJ-45 ports for the ACX500 outdoor routers.
Copyright © 2016, Juniper Networks, Inc.