ACX500 Universal Access Router Hardware Guide
132
Figure 55: Installing the ACX500 Outdoor Router Cable Seal on the
Interface Cable
1—
Interface cable
2—
Outer cover of cable seal
Repeat steps
5
through step
7.
Leave in place the hole-plugs for the unused cable seal groove holes.
Push back the cable seal enclosing the interface cable back into the cable connector
8.
unit.
Provide enough cable slack to reach the connector.
9.
Tighten the connector screw's thread end along with the cable seal inside it back into
10.
the connector enclosure port on the router. See
Figure 56: Installing the ACX500 Outdoor Router Connector Screw
3—
Rubber cable seal with grooves
4—
Hole-plugs
6
for the remaining RJ-45 interface cables, as required.
Figure 56 on page
Copyright © 2016, Juniper Networks, Inc.
132.