Figure 49: Installing The Acx500 Outdoor Router Cable Seal On The Interface - Juniper ACX500 Hardware Manual

ACX500 Universal Access Router Hardware Guide
126
NOTE:
The cable seal with single groove must be used for the SFP interface
cables, and the one with three grooves must be used for the RJ-45
interface cables.
Ensure that each groove on the rubber cable seal accommodates only
one cable through it.
Leave at least 2 in. (5.08 cm) of interface cable for connecting it to the
transceiver.
Figure 49: Installing the ACX500 Outdoor Router Cable Seal on the
Interface Cable
1— Interface cable
2— Outer cover of cable seal
Push back the cable seal enclosing the interface cable back into the cable connector
8.
unit. See Figure 50 on page
The connector enclosure connects directly to the router's cable inlet port. The cable
seal wraps the interface cable and, along with the connector screw on top of it, makes
the whole unit watertight and dustproof.
3— Rubber cable seal with groove
4— Hole-plugs
127.
Copyright © 2016, Juniper Networks, Inc.