Ramp Warning; Acx500 Chassis Lifting Guidelines - Juniper ACX500 Hardware Manual

ACX500 Universal Access Router Hardware Guide

Ramp Warning

Related
Documentation

ACX500 Chassis Lifting Guidelines

206
WARNING: When installing the hardware equipment, do not use a ramp
inclined at more than 10 degrees.
Waarschuwing Gebruik een oprijplaat niet onder een hoek van meer dan 10
graden.
Varoitus Älä käytä sellaista kaltevaa pintaa, jonka kaltevuus ylittää 10 astetta.
Attention Ne pas utiliser une rampe dont l'inclinaison est supérieure à 10
degrés.
Warnung Keine Rampen mit einer Neigung von mehr als 10 Grad verwenden.
Avvertenza Non usare una rampa con pendenza superiore a 10 gradi.
Advarsel Bruk aldri en rampe som heller mer enn 10 grader.
Aviso Não utilize uma rampa com uma inclinação superior a 10 graus.
¡Atención! No usar una rampa inclinada más de 10 grados
Varning! Använd inte ramp med en lutning på mer än 10 grader.
General Safety Guidelines for Juniper Networks Devices on page 193
General Safety Warnings for Juniper Networks Devices on page 194
Maintenance and Operational Safety Warnings for Juniper Networks Devices on page 213
The weight of a fully configured ACX500 indoor router is about 8.6 lb (3.9 kg). The
AC-powered ACX500 outdoor router weighs about 18.2 lb (8.3 kg) and the DC-powered
ACX500 outdoor router weighs about 17.5 lb (7.9 kg). The AC-powered ACX500 outdoor
router with PoE weighs 18.7 lb (8.5 kg), and the DC-powered router weighs 18.6 lb (8.4 kg).
Observe the following guidelines for lifting and moving the router:
Before moving the router, read the guidelines in
Routers" on page 53 to verify that the intended site meets the specified power,
environmental, and clearance requirements.
Before lifting or moving the router, disconnect all external cables.
"Site Preparation Checklist for ACX500
Copyright © 2016, Juniper Networks, Inc.