CHAPTER 17
Replacing Chassis Components
Replacing a Console Cable
Removing a Console Cable
Installing a Console Cable
Copyright © 2016, Juniper Networks, Inc.
Replacing a Console Cable on page 161
Replacing a Management Ethernet Cable on page 162
Replacing a Fiber-Optic Cable on page 162
Replacing an SFP Transceiver on page 164
Removing a Console Cable on page 161
1.
Installing a Console Cable on page 161
2.
To remove a serial cable connected to a console device:
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Press the tab on the connector, and pull the connector straight out of the
2.
port.
Figure 71 on page 161
Disconnect the cable from the console.
3.
Figure 71: Ethernet Cable Connectors
The
port on the front panel of the router accepts an RS-232 (EIA-232) serial
CONSOLE
cable with RJ-45 connectors.
To connect a cable between the router and the console device:
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Connect one end of the replacement cable into the
2.
shows the connector.
CONSOLE
CONSOLE
port.
161