Mounting The Acx500 Outdoor Router On A Wall; Figure 38: Installing The Acx500 Indoor Router In The Rack - Juniper ACX500 Hardware Manual

Related
Documentation

Mounting the ACX500 Outdoor Router on a Wall

Copyright © 2016, Juniper Networks, Inc.
Position the router in front of the rack or cabinet.
3.
Hold onto the bottom of the chassis, and carefully lift it so that the mounting brackets
4.
contact the rack rails. See
WARNING: To prevent injury, keep your back straight and lift with your
legs, not your back. Avoid twisting your body as you lift. Balance the load
evenly and be sure that your footing is solid.

Figure 38: Installing the ACX500 Indoor Router in the Rack

Mounting rack
Align the mounting brackets with the holes in the rack rails.
5.
Install a mounting screw into each of the open mounting holes on the mounting bracket
6.
aligned with the rack, starting from the bottom.
Visually inspect the alignment of the router. If the router is installed properly in the
7.
rack, all the mounting screws on one side of the rack should be aligned with the
mounting screws on the opposite side, and the router should be level.
Site Preparation Checklist for ACX500 Routers on page 53
Installing and Connecting an ACX500 Indoor Router Overview on page 101
Connecting the ACX500 Router to Earth Ground on page 135
NOTE: The information provided in this topic is applicable for both the
ACX500 outdoor router variants—ACX500 outdoor router and ACX500
outdoor router with PoE.
Chapter 12: Installing the ACX500 Router
Figure 38 on page 111.
Mounting bracket
111