ACX500 Universal Access Router Hardware Guide
Related
Documentation
Replacing a Management Ethernet Cable
Removing a Management Ethernet Cable
Installing a Management Ethernet Cable
Related
Documentation
Replacing a Fiber-Optic Cable
162
Plug the other end of the cable into the device's serial port.
3.
Console Port Connector Pinout on ACX500 Routers on page 78
Removing a Management Ethernet Cable on page 162
1.
Installing a Management Ethernet Cable on page 162
2.
To remove a serial cable connected to a management device:
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Press the tab on the connector, and pull the connector straight out of the
2.
Figure 72 on page 162
shows the connector.
Disconnect the cable from the network device.
3.
Figure 72: Ethernet Cable Connectors
To install a serial cable connected to a management device:
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Plug one end of the replacement cable into the appropriate
2.
Plug the other end of the cable into the network device.
3.
Management Port Connector Pinout Information for ACX500 Routers on page 77
To replace a fiber-optic cable:
Disconnecting a Fiber-Optic Cable on page 163
1.
Connecting a Fiber-Optic Cable on page 163
2.
MGMT
port.
MGMT
Copyright © 2016, Juniper Networks, Inc.
port.