Copyright © 2016, Juniper Networks, Inc.
Figure 54: Cable Connector Unit
1—
Connector enclosure
2—
Interface RJ-45 cable
Slide the interface cable up to at least 2 in. (5 cm). into the cable seal groove. See
6.
Figure 55 on page
132.
The grooves in the cable seal have slits that help push the cables easily into the groove.
NOTE:
The cable seal with single groove must be used for the SFP interface
cables, and the one with three grooves must be used for the RJ-45
interface cables.
Ensure that each groove on the rubber cable seal accommodates only
one cable through it.
Leave at least 2 in. (5 cm) of interface cable for connecting it to the
transceiver.
Leave in place the hole-plugs for the unused cable seal groove holes.
Chapter 12: Installing the ACX500 Router
3—
Cable seal
4—
Connector screw
131