Table of Contents
Advertisement
Cable clip
2
Figure 199. Video and USB breakout signal cable routing
Step 4.
Reconnect the video and USB breakout signal cable to the KVM assembly; then, install the two
screws to secure the KVM assembly to the side of the chassis.
Note: Use the hex screw driver to install the two screws.
KVM connector
assembly
Figure 200. KVM assembly installation
Step 5.
Insert the SAS, power and operator information panel cables into the cable clips. The power cable
is present when the third backplane is installed in the server.
Video and USB
breakout cable
1
Hex screw driver
.
Chapter 6
Removing and replacing components
277
Advertisement
Table of Contents
Troubleshooting
