Table of Contents
Advertisement
USB embedded
hypervisor
flash device
Figure 187. USB hypervisor flash device installation
a.
Align the flash device with the connector on the system board and push it into the USB
connector until it is firmly seated.
b.
Slightly pull up on the blue lockbar to lock the flash device into the USB connector.
Step 6.
Reconnect the power cords and any cables that you removed.
Step 7.
Replace the cover (see "Replacing the cover" on page 196).
Step 8.
Slide the server into the rack.
Step 9.
Turn on the peripheral devices and the server.
Removing the system battery
The following notes describe information that you must consider when remove the battery.
• Lenovo has designed this product with your safety in mind. The lithium battery must be handled correctly
to avoid possible danger. If you replace the battery, you must adhere to the following instructions.
Note: In the U. S., call 1-800-IBM-4333 for information about battery disposal.
• If you replace the original lithium battery with a heavy-metal battery or a battery with heavy-metal
components, be aware of the following environmental consideration. Batteries and accumulators that
contain heavy metals must not be disposed of with normal domestic waste. They will be taken back
free of charge by the manufacturer, distributor, or representative, to be recycled or disposed of in a
proper manner.
• To order replacement batteries, call 1-800-IBM-SERV within the United States, and 1-800-465-7999 or
1-800-465-6666 within Canada. Outside the U.S. and Canada, call your Lenovo sales representative or
Lenovo reseller.
266
Lenovo System x3650 M4 HD Installation and Service Guide
Lockbar
Advertisement
Table of Contents
Troubleshooting
